04-14-2024, 05:32 AM
|
#76 |
|
Join Date: Jul 2015
Posts: 36
|
Hi all I have a question about the Rocker arms Pins orientation. I had to do service of top end of my bike engine as one of the baring has fail on the camshaft, lucky, I have stop using the bike immediately when start hearing some ode noises in the engine. I did replace the rocker arms with pins but now I am not sure if I have installed the pins correctly… Where should be the flat spot of Pins orientated – UP towards petrol tank or Down towards ground? Thanks for Help
|
|
|
Today, 08:20 AM
|
#77 |
|
Join Date: Jul 2015
Posts: 36
|
I will answer my self on the above question about orientation of Rocker arms pins.
First I have whach all videos on YouTube and on one I have spotted the correct orientation: CSC RX3 Engine teardown by Sifu Carlos Second I have asked CSC directly and after some time I have get answer: "The flat spot faces up and the 2 little oil holes face down." So I have asemble the bike and tested for 2 weeks already and can confirm that the above is correct All the best for everyone 
|
|
|
|
|
|
 |
|
|
Linear Mode
