|
|
10-24-2018, 02:54 PM
|
#1 |
|
Join Date: Jul 2015
Posts: 36
|
Hi tere
Is there anyone know where to find the “Short term fuel trim” and “Long term Fuel trim” on this PCHUD program ??? Is there any place where I can find the following figers from PCHUD explained??? Engine Speed - Engine Speed Battery Voltage- Actual battery Voltage Coolant temp – Actual Coolant Temperature measured in thermostat housing Intake Air TEMP- Intake air temperature measured by MAP sensor Pump Duty Cycle – measured in percent Spark Dwell time – length in time of spark IPACV- ??? Exhaust temp - I gees measured by 02 sensor Air Fuel Ratio – Air Fuel Ratio 14,71 / 1 in perfect world Target A/F ratio - ECU is making this Target for Air Fuel Ratio BLM LEARN VALUE 1- ??? CLC INT LEARN V 1- ??? Fuel Pulse Width 1 – how long time the injector is injecting fuel DESIRED IGN TIMING- ??? CCE1 - ??? CLC CORR COEFF1 - ??? BLM CELL NUMBER- ??? DYNAMIC SA- ??? Fuel Pulse Width 1 – how long time the injector is injecting fuel DESIRED MOTOR STEPS – location of the valve from 0 – 132 IDLE VOL LEARN VAL - ??? Desired idle rpm – ECU is trying to achieve this given value Idle RPM error – difference between ; Desired idle rpm and actual idle rpm 23 ERROR counter- ??? Atmospheric pressure- actual Atmospheric pressure Current fault code - Current fault code which has occurred Historic fault code - Historic fault code stored in ECU Measured MAP – pressure in kpa measured by MAP sensor in throttle body but not sure way is so low EXPECTED MAP- EXPECTED pressure measured by MAP sensor O2- Voltage – voltage which passing by O2 sensor depend on amounts of oxygen in exhaust gases Throttle Position- actual Throttle Position Throttle Value- not sure Thank You |
|
|
|
|
 |
|
|
Hybrid Mode
