Forum: Zongshen RX3
10-18-2017, 03:11 PM
|
|
Replies: 33
Views: 10,313
|
|
Forum: Zongshen RX3
09-22-2017, 05:45 PM
|
|
Replies: 3
Views: 1,509
How to Find local Shops
Hi,
Is there such a thing as a list of shops by city or ZIP code that work on the RX3?
I need to have the valves adjusted, and all local shops that I have called (about eight) say they don't...
|
|
Forum: Zongshen RX3
04-18-2017, 09:14 AM
|
|
Replies: 16
Views: 3,785
|
|
Forum: Zongshen RX3
04-14-2017, 10:06 AM
|
|
Replies: 29
Views: 5,254
|
|
Forum: Zongshen RX3
02-08-2017, 02:53 PM
|
|
Replies: 109
Views: 31,846
RJ, too late: grinding is done and stand is...
RJ, too late: grinding is done and stand is installed...you are right as we seem to be on opposite ends of the west coast - I live less than ten miles from the USA-Mexico border.
I would have...
|
|
Forum: Zongshen RX3
02-07-2017, 03:51 PM
|
|
Replies: 109
Views: 31,846
I sent an email to CSC two days ago, and their...
I sent an email to CSC two days ago, and their recommendation is to grind the mounting points too. So I 'll just go ahead and do it - using my Dremel tool and a grinding stone.
They proposed three...
|
|
Forum: Zongshen RX3
02-07-2017, 08:51 AM
|
|
Replies: 109
Views: 31,846
Jay, thanks for your response.
Based on the...
Jay, thanks for your response.
Based on the pictures below, it will be about 1.5mm of grinding per side (sorry, last picture is upside down).
Once ground, is it needed to paint the bare metal...
|
|
Forum: Zongshen RX3
02-07-2017, 02:20 AM
|
|
Replies: 109
Views: 31,846
Hi Guys! I am new to this forum, and this is...
Hi Guys! I am new to this forum, and this is actually my first post. Sorry if I am breaking protocol with this message as I still have a lot to learn about forum rules.
The issue I found with the...
|
