Ok Mr Weld!
I got those measurements:
I used a mastercraft digital caliper to give me my readouts.
Piston bore size : 64.84MM (65MM bore)
Top of piston to bottom of skirt : 42.58MM (42.5m
Wrist Pin : 14.97MM (15MM)
Top of piston to top of Wrist pin : 14.64MM
Top of piston to center of wrist pin : 22.12MM
I think I gathered up 0.072" clearance at TDC from the piston top to the edge of the cylinder head where the piston would first contact if it centered too high.
Can I plain 0.035" off my culinder's deck to gain a little on my CR?
__________________
Gio X31 Paid $440 for the bike new in the crate! Currently a modified, high compression, head turning MONSTER!
|