I have maybe just over 200 miles on the Templar. I changed the oil and adjusted the exhaust valve (back to ~ 0.006inch). It had tightened up a little. The intake was still at ~ 0.005inches.
I took the plug out for the procedure to make it easier to control. While adjusting, I noticed that the crankshaft spins very nicely, and in fact the valve springs rotate the shaft as the cams roll off to zero lift. Smooth as silk (and good strong valve springs). Nice!
Here is a picture of the plug. Looks perfect. It is a YouALL smoothbore PE30.
OEM Main jet was #120. Changed to #125
OEM Pilot jet was #40, Changed to #45 (#42 is better-#45 doesn't need choke for cold weather start)
One washer shim on the needle (~1mm).
It starter instantly and ran GREAT when I got it all back together. I took a quick trail ride and had a blast
Perfect jetting.
