Quote:
|
Originally Posted by warrior91
I have seen a clamp around the bearing carrier itself on sport models(round tube style) and braced it further to the mounting holes for the wimpy stock "protector :roll: ".
For my sport bike,I built a new swingarm protector from scratch and added a Towing lug directly to it... :wink:
|
Quote:
|
Originally Posted by smoothie911
I would like to see a pic of that warrior
|
I've seen that, too- someone hadf a muffler clamp around the bearing carrier, with a L-shaped piece of metal coming out over the bikes trailer hitch. Such an arrangement might beef up the hitch a little....but one would still have to be very careful, as there is not much holding that bearing carrier/rear axle to the swingarm, and I could just see all kinds of havoc breaking loose if one were to put too much stress on that carrier/axle and skew it. (Like the chain popping off from being out of alignment, and never being able to align it properly again....)