04-06-2016, 02:31 PM | #1 |
Join Date: Jun 2015
Location: Escondido, CA
Posts: 117
|
Voltage ?
Please don't laugh too hard, because I really don't understand the electrics of the bike.
A little while ago I was having trouble starting my bike, which I assumed was a weak battery. The valves had been adjusted only 800 miles ago and the bike was running great once I got it started. The bike starts immediately with the new battery. At that time I didn't have a Multimeter available to test the battery. I ordered and received a multimeter today. I charged the OEM battery and kept it in my shed. I just tested it and it read 12.7 Volts. Then I took the seat off the mighty RX3 and tested my new battery. I just returned home after a pleasant ride to breakfast. The new battery read 13.7 Volts (engine off) and 14.7 Volts with the bike idling. I understood that the RX3 was suppose to have between 12.5 - 13 Volts Is my bike charging too much? What should the Volt meter read? I'm using an Etekcity MSR-R500 digital multimeter. Thanks
__________________
Dave |
|
04-06-2016, 03:03 PM | #2 |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
Don't worry just yet; your bike is probably operating perfectly.
The stator and regulator/rectifier will charge the motocycle at 14.7 volts while the engine is running at higher rpms. At lower engine speeds, the charging voltage should be lower. As long as you don't exceed a charging voltage of 14.7 volts, the bike is charging the battery properly. Immediately upon turning the bike off, the battery voltage will be a little high. However, after the bike rests for an hour or so, the voltage of a new battery will stabilize around 12.8 volts.
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain 2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
04-06-2016, 11:34 PM | #3 |
Join Date: Mar 2009
Location: Sardis, BC, Canada
Posts: 25,977
|
BTW, those were excellent questions, Dave. You never know whom else might benefit from reading this thread.
To expand on your findings, if you ever suspect that your bike isn't charging the battery, test the battery with the bike off, and then again with it running. If you don't see an increase in voltage with the bike running, it's not charging the battery.
__________________
Weldangrind "I figure I'm well-prepared for coping with a bike that comes from the factory with unresolved issues and that rewards the self-reliant owner." - Buccaneer |
|
04-07-2016, 01:07 AM | #4 |
Join Date: May 2007
Location: Warshington
Posts: 928
|
I got one of these off Ebay and they work great for seeing what your voltage is doing. Do a search for them and you can see pics of the other side that shows the voltage in an LCD window. So small I leave it on one of my battery tender leads all the time. rj
http://www.ebay.com/itm/Battery-Tend...tWUigy&vxp=mtr
__________________
Live Zong, and Prosper |
|
04-07-2016, 01:17 AM | #5 |
Join Date: Feb 2016
Location: George West, Texas
Posts: 4,097
|
I picked this up for my 12v plug I installed in my dash. So far so good.
http://www.amazon.com/Charger-Voltme...ilpage_o06_s00
__________________
***************************************** 2015 Bashan"Blaze" BS250GY-31 (DB-07K-250) GONE 2017 Suzuki V Strom 650 XT "We are all born ignorant, but one must work hard to remain stupid." ~Benjamin Franklin~
|
|
07-31-2016, 11:38 PM | #6 |
Join Date: Apr 2016
Posts: 2
|
voltage regulator/charging unit
I replaced my battery cause it was too weak for three, four starts in a short time.....after 1 week I face the same problem, then I checked the charging voltage....13,5 ...that should be too low, and even when I unscrew the battery the voltage is not increasing....should I change the charging unit (under the seat)
Zongshen RX3 |
|
08-01-2016, 12:02 AM | #7 | |
Join Date: Jul 2015
Location: Milpitas, CA. USA
Posts: 775
|
Quote:
If you don't find a problem with any connections, then test the charging system with a meter at each component to find which part is not working correctly. Keep them bright and keep them tight. Good luck. |
|
|
08-01-2016, 09:04 AM | #8 |
Join Date: Apr 2016
Location: South Mississippi
Posts: 253
|
I have learned an enormous amount from these forums... so, here's my question...when riding, I'm at 14.2 - 14.3 volts. Still within normal range?
|
|
08-01-2016, 10:23 AM | #9 | |
Join Date: Feb 2016
Location: Portsmouth, Virginia, USA
Posts: 632
|
Quote:
Peter Y. |
|
|
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|