valve clearances

stilkikin · 12-01-2008, 11:44 PM

Does anybody know the specs for the valve clearances for a pushrod 125? I don't know for sure but I'm going to go with the specs from a 200 if nobody knows because anything would be better than the rattletrap I have now. Thanks fo any info.

humanbeing · 12-02-2008, 01:39 AM

The engine is based on Honda CG125. Most repair book recommended 0.08mm but some "crazy" ppl in China recommended narrower gap.

The rough translated chinese article about how to tune these engine.

stilkikin · 12-02-2008, 10:19 PM

thank you very much.

12-01-2008, 11:44 PM	#1
stilkikin Join Date: Oct 2008 Location: East TN Posts: 28	valve clearances Does anybody know the specs for the valve clearances for a pushrod 125? I don't know for sure but I'm going to go with the specs from a 200 if nobody knows because anything would be better than the rattletrap I have now. Thanks fo any info.
	0

12-02-2008, 01:39 AM	#2
humanbeing Join Date: Mar 2008 Posts: 2,436	The engine is based on Honda CG125. Most repair book recommended 0.08mm but some "crazy" ppl in China recommended narrower gap. The rough translated chinese article about how to tune these engine.
	0

12-02-2008, 10:19 PM	#3
stilkikin Join Date: Oct 2008 Location: East TN Posts: 28	thank you very much.
	0