Help with running issues on Shineray XY200GY

kevshek · 11-24-2011, 10:41 AM

sure did! i went old skool and used a compass? those pencil on the inverted V thing LOL and drew the 2 circles, then used a knife and scissors.

While waiting about i decided to bore out the inlet side of the head. Out came the dremmel!

Before

After

Anyways, manifold arrived about an hour or 2 ago, first thing i did as bore it out some, as he carb is bigger, now the had is bigger. After that i set about fitting the paper gasket and rubber ring.

Above you can see the O ring sitting proud, i only used one of the paper gaskets. On the right side, thats te O ring seated and uncompressed so theres plenty rubber to make a good seal.

Anyways the bike is all back together now and running lovely, thanks to you guys. I may try the bigger slow jet of 2.5 next time im in there. The bike is much better on part throttle, but i can still feel a slight hesiation while at low throttle in a high gear. I think the mixture screw is near to 2 turns out, but will double check when it cools down.

Thanks peeps.

11-24-2011, 10:41 AM	#29
kevshek Join Date: Nov 2011 Posts: 49	sure did! i went old skool and used a compass? those pencil on the inverted V thing LOL and drew the 2 circles, then used a knife and scissors. While waiting about i decided to bore out the inlet side of the head. Out came the dremmel! Before After Anyways, manifold arrived about an hour or 2 ago, first thing i did as bore it out some, as he carb is bigger, now the had is bigger. After that i set about fitting the paper gasket and rubber ring. Above you can see the O ring sitting proud, i only used one of the paper gaskets. On the right side, thats te O ring seated and uncompressed so theres plenty rubber to make a good seal. Anyways the bike is all back together now and running lovely, thanks to you guys. I may try the bigger slow jet of 2.5 next time im in there. The bike is much better on part throttle, but i can still feel a slight hesiation while at low throttle in a high gear. I think the mixture screw is near to 2 turns out, but will double check when it cools down. Thanks peeps.
	0