03-19-2015, 09:15 PM | #1 |
Join Date: Oct 2014
Posts: 187
|
M3C LED Bulb Installation in a Baja Light
Hello, [Bike (LF200GY-2) 2007 ]
I just got this bulb here, http://micarslighting.en.alibaba.com...headlight.html I have a Baja Headlight, it came with an H4 Bulb, I will be removing this bulb for the LED Bulb, the Headlight also has another little light in it as well, I think that's the Low Beam light? not to sure, at the back of the case it has a Black and Green wires, the black wire looks like a female connector and the green wire looks like a male connector, do I need to connect these wires to anything or no? and if so where do these wires go? I have a picture #1 to show you. The Baja Light Switch has the connector that connects to the harness that I got with the package, that would be the "yellow, green, red, and blue wire. Also there is a White and Black Male connectors too shown in the picture #2, where do these wires connect too and what are they for? On the Light Switch, I have High/Low/ Kill Switch buttons. Where and How do I connect the 3 Wires coming from the M3C Led bulb? The Bulb does have a fan at the back, and I heard its a good idea to cut a hole into something for a heat relief, the bulb gets someone hot. I hope someone has this bulb and can give me the best pointers. Shown in Picture #3 I believe this bulb can do High/Low beam, is this true? With the wire harness that come with the Baja Headlight Kit picture #4, is it ok to connect a 2nd Black and Red wire to my Battery since there is already a harness in my bike?... At the very end of the harness is a connector for a tail light, I would like to hardwire this taillight so it automatically comes on when I turn my headlight on, I do NOT have a rear tail light switch. I don't know how to do this. In Picture #5 it shows the wires. Thank you for the help, its a lot of fun working on this bike and I'm learning a lot about everything on the inside |
|
|
|
|
|