New Zongshen RX3 (ZS250GY-3) Dual Sport

[woodlandsprite]

Originally Posted by rjmorel

When I did my hand guards I found the hole in the bars to be already very close to 1/2" though out of round so a 1/2" bar wouldn't go in. So I just used a 1/2" drill bit to kind of ream out the out of roundness. Didn't remove much material. Then I turned the hand guard mount down to 1/2" to fit. rj

Thanks RJ
just so I understand - you had to dremel/modify your hand guard mounts a hair to fit inside the 1/2" hole?