10-17-2010, 06:06 PM
|
#16 |
|
Join Date: Aug 2009
Location: London, Ontario
Posts: 1,097
|
Well had the bike out today, jetting is close but needs to be a tad richer on the lowend, i'm thinking a 27.5 pilot instead of the 25 is needed, the deflector seemed to do it's job today, lots o crap on the outside and very little on the filter side, i'm also going to get an Outerwear to put on the filter to keep the bigger chunks off (if any actually get in) and they also help keep water off the filter. Didn't have time at the shop today to make the plug so i just bolted the starter back in place to seal up that hole, maybe next time.
|
|
|
10-18-2010, 10:33 PM
|
#18 |
|
Join Date: Aug 2010
Location: austin, tx
Posts: 1,452
|
could you use the end cap of the starter ? the peice that the long bolts go into, if needed i can snap a picture of said peice on my quad to show you.
all you would need is some shorter bolts..
__________________
200cc beast replica,carsoli cdi,performance coil,fmf powercore 2,uni air filter,hour/tach meter,jetted mikuni carb,msr bars,moose racing grips,yz250f clutch perch,D.I.D chain |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
