Pro Circuit Exhaust T4 Install on the Qlink

[JTCAndrew]

Ok Here it is - Installed the Pro Cicuit T4 on my 2009 QLINK XF200 Today.

The Stock SYSTEM



Stock Header



Stock - Man this This HUGE and Heavy!



NEW and OLD Comparison - The Pro Circuit is WAY WAY Lighter!





New Header Pipe - I am Going to have to add a Washer in here becuase I didn't like the Sloppyness - Just have to add a washer to get her to tighten up a bit more - But fits nice.




Added Some Header Tape under the AIRBOX because I didn't like that is was a little closer then the stock pipe - But with a little adjustment could be moved away - Just bad measurement on my part with the rear hanger.



A Rear Hanger needed to be made and fabricated for proper fitment. -











I added The rubber to the hanger from the original Exhaust Hanger -









Pipe Fitment is Good with alittle adjusting here and there -No Problems





Next I had to Fabricate a Lower Bracket to STRENGTHEN up the System all togather!







The Finished Product -











I am VERY Please with the overall Complete Exhuast System - Only had to Fab up a few Brackets and Hangers to tighten everything up real well. You could actually get away with Mounting this system without making any extra brackets etc....But I wanted to make sure this new exhuast system wasn't going anywhere once she was on.
NEXT will be Sound Clips for this system - I will add these later. I am going to put my NEW Jets in Soon. - Stay posted. Also waiting on my NEW 16T Front Sprocket to arrive.
While I was doing the Exhaust I also cut the tail OFF the back of the Bike and Constructed up a Inspection Plate for our wonderfull state of Pennsylvania - They usually stick them to your front fork - BUT as you can see there was no real place to put it - So I made the Plate -










Hope this Helps anyone considering this mod - Useful Information! Please feel free to ask any questions on this pipe and I will be happy to answer!
Andrew - Jamestown, PA 16134