05-21-2020, 10:25 PM | #2 | |
Join Date: Apr 2017
Location: Omaha, NE
Posts: 8,100
|
Quote:
Assuming float height is set correctly, the next thing I would check for is that you don't have a vacuum leak. That would play hell with all of the mixture settings. Also, what mods, if any on the bike?
__________________
Hawk Information and Resource guide: http://www.chinariders.net/showthread.php?t=20331 2018 Hawk 250 - Full Mod list here. http://www.chinariders.net/showpost....62&postcount=1 2024 Royal Enfield Shotgun 650 https://chinariders.net/showthread.php?t=34124 |
|
|
05-22-2020, 12:04 AM | #3 |
Join Date: Oct 2015
Location: connecticut
Posts: 980
|
Dan correct me if I'm out of touch but my hawk was shipped with tight valves and that needs ro be checked first, right?
|
|
05-22-2020, 12:07 AM | #4 |
Join Date: Apr 2017
Location: Omaha, NE
Posts: 8,100
|
Also a possibility, yes.
__________________
Hawk Information and Resource guide: http://www.chinariders.net/showthread.php?t=20331 2018 Hawk 250 - Full Mod list here. http://www.chinariders.net/showpost....62&postcount=1 2024 Royal Enfield Shotgun 650 https://chinariders.net/showthread.php?t=34124 |
|
05-22-2020, 01:17 PM | #5 |
Join Date: Apr 2020
Location: mid michigan
Posts: 5
|
I have two hawks both run 40 / 110 , two turns and two washers . maybe a little lean . ive had this tbr7 for a month ,still doesn't run.
it can with a broken primary jet. had to buy a new carb . |
|
05-22-2020, 02:17 PM | #6 |
Join Date: Apr 2020
Location: mid michigan
Posts: 5
|
Ok I checked the float level .good. sprayed it down , no vac leak. The only mod is cat removed. Ok 45 / 110 jets ,third slot on needle . will not run in the middle ..
|
|
05-22-2020, 08:37 PM | #7 |
Join Date: Apr 2020
Location: mid michigan
Posts: 5
|
Ok im going with 40 /110 adjust the needle up to the forth slot . Starting there again. I took the carb all apart and cleaned .Hope this works
|
|
|
|
|
|