|
05-27-2021, 07:58 PM | #1 | |
Join Date: May 2021
Location: Earth
Posts: 1
|
Quote:
https://www.yoycart.com/Product/5753...es_KPM200_LF20 Otherwise, you may also check these listings: https://www.yoycart.com/Search?Searc...atId=0&catId=0 I had to purchase one myself so good luck! Last edited by skywardabyss; 05-27-2021 at 07:58 PM. Reason: Spacing |
|
|
06-05-2021, 03:27 AM | #2 |
Join Date: Apr 2020
Location: Ohio
Posts: 83
|
Found a place for replacement parts
https://kpclubusa.com/collections/kpm-200 |
|
06-05-2021, 06:41 AM | #3 | |
Join Date: Aug 2020
Location: Savannah, Ga
Posts: 760
|
Quote:
|
|
|
06-05-2021, 06:52 AM | #4 |
Join Date: Aug 2020
Location: Savannah, Ga
Posts: 760
|
I will say this, though. Watch the pricing on that place. The KP200 and the KPM200 share the same suspension, wheels, and brake components. But the KP200 parts are cheaper than the KPM200.
|
|
07-12-2021, 11:09 PM | #5 |
Join Date: Jul 2021
Location: High Desert
Posts: 12
|
I couldn't find that kpmoto club exhaust anywhere and took a chance on an exhaust for the kpt200 which seems to work just fine. Only thing is that the flange/spacer piece going into the header was just a bit shorter. Shimmed them up with an additional washer and it pretty much bolts right up. Also the sensor is in a slightly different place but still fit fine. Definitely sounds better. Can't say I've noticed a performance difference but I also don't have a ton of miles on her yet.
You can see it here https://www.aliexpress.com/snapshot/...05001616982790
__________________
2021 Lifan kpm 200 1978 Honda cb550k - in various stages of being rebuilt |
|
11-02-2021, 02:46 PM | #6 |
Join Date: Nov 2021
Posts: 2
|
Oil question
I saw the type and the filter I can change it with but I was wondering how much oil do the kpms take? Sorry this is my very first motorcycle so I don’t know much about them. Thank you for any help
|
|
11-02-2021, 03:18 PM | #7 |
Join Date: Aug 2020
Location: Savannah, Ga
Posts: 760
|
They take about a quart. There is a sight glass to check oil level. Just make sure when you're filling it back up, and the bike is straight up and down, and not on it's kickstand. Fill slowly, as the oil takes a while to get to the sight glass. Once you make it to level put the fill cap back on, start the bike and let to run for about 30 seconds, then check the oil again after a couple minutes. Add oil if needed to get back to the proper level.
|
|
11-02-2021, 03:27 PM | #8 | |
Join Date: Nov 2021
Posts: 2
|
Quote:
Thank you so much. Should I see the oil while the bike is running or when it’s cool? |
|
|
11-02-2021, 03:44 PM | #9 |
Join Date: Aug 2020
Location: Savannah, Ga
Posts: 760
|
When the bike is not running. So far, the only time I've ever had a bike that showed low when not running has been my RC390. You had to start the bike, then turn it off to see the oil level. lol.
|
|
08-05-2021, 10:48 AM | #10 |
Join Date: Aug 2021
Posts: 5
|
What's the coolant type for the KPM ? My owner's manual has a coolant section, but it doesn't mention what to put in it
|
|
09-03-2021, 09:52 AM | #11 |
Join Date: Aug 2020
Location: Savannah, Ga
Posts: 760
|
https://www.yoycart.com/Product/649820300216/
Here's the sprocket. I actually forgot that I ordered these. I tried to order through these guys, and apparently, it didn't get paid, so I was never charged. My security features on my card are super hardcore, so unusual purchases to other countries are flagged and blocked immediately. That's a very good thing, but makes it hard to buy stuff sometimes. lol |
|
09-03-2021, 12:17 PM | #12 |
Join Date: Jul 2021
Location: High Desert
Posts: 12
|
Has anyone found a wiring diagram? Doing a walk around today I noticed my rear brake pedal doesn't trigger the light and also the high beam switch doesn't work. The momentary finger switch works, but not the wide beam thumb switch.
__________________
2021 Lifan kpm 200 1978 Honda cb550k - in various stages of being rebuilt |
|
06-06-2022, 12:44 PM | #13 | |
Join Date: May 2022
Location: McKinney, TX
Posts: 53
|
Quote:
https://cdn.shopify.com/s/files/1/02...f?v=1639718102 |
|
|
09-03-2021, 01:09 PM | #14 |
Join Date: Aug 2020
Location: Savannah, Ga
Posts: 760
|
No wiring diagrams as of yet, as far as I know. There might be a simple one line in the manual. That could be a start. I know my horn button no longer works. But, that's because it sat out in the weather for a month last winter
Last edited by Falkon45; 09-03-2021 at 04:06 PM. |
|
09-03-2021, 01:17 PM | #15 |
Join Date: Jul 2021
Location: High Desert
Posts: 12
|
Turns out the headlamp works only when the bike is running, which is weird but fine for now. The rear brake light switch is still a problem and I don't see any obvious wires.
__________________
2021 Lifan kpm 200 1978 Honda cb550k - in various stages of being rebuilt |
|
|
|
|
|