Go Back   ChinaRiders Forums > SpudRider
Register FAQ Community Calendar Today's Posts Search
Conversation Between SpudRider and AdventureDad
Showing Visitor Messages 1 to 4 of 4
  1. AdventureDad
    11-18-2016 07:38 PM
    AdventureDad
    Hey Spud. ..took my rear shock linkage off to regrease it. Also removed the swingarm. The brake side was very dry. Anyhow. .for the torque spec sticky, you can add the swingarm torque spec per Gerry at csc is 54 ft lbs. I appreciated your how to on this!
  2. SpudRider
    04-19-2016 01:50 PM
    SpudRider
    Read post #2 in the following thread for connector information.

    http://www.chinariders.net/showthread.php?t=15437
  3. SpudRider
    04-11-2016 12:40 PM
    SpudRider
    You are correct. However, I would not clip the wires on the auxiliary harness. I installed the appropriate connector. Also the green wire of the harness is the ground wire, and the other wire, I believe it is pink, is the hot wire.
  4. AdventureDad
    04-08-2016 02:39 PM
    AdventureDad
    I had a question re: LED aux lights as it looks like you and I have the same ones. To install them to the handlebar A1/A2 switch, from the lights, I would tie both negative leads together, join both positive leads, run the 2 wires (pos and neg) to one of the leads noted in the tutorial, clip the plastic plug off, see which one is hot with a continuity tester, and splice them together. Am I correct in all this? Thanks a million!

All times are GMT -4. The time now is 07:31 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.