Oil plug on Magician 250cc

jdiaz135 · 02-26-2020, 08:51 AM

Hey guys,

So I have 400 miles on my magician. I bought oil and I am ready to change the oil for the first time but I cannot seem to loosen the oil bolt. Im using a ratchet but it will not budge.

Its very possible that im just not using enough strength and that all I need to do is push a little hard and it may loosen but im afraid to hurt myself.

Anyway, is there something that im missing or is it just simply VERY tight?

Thanks!!

**JerryHawk250** · 02-26-2020, 08:55 AM

Both my drain bolt on the bottom and the plug on the side where the filter screen is located were very tight on my Hawk and my X22R. Just makes sure you are turning lefty loosie.

jdiaz135 · 02-26-2020, 08:57 AM

Okay, I figured. Ill try again. thank you

imapdog · 02-26-2020, 09:00 AM

yes my two magicians were very tight on the drain plug. using a long handle/extension lefty way does the job. i did not attempt to re tighten it back with the long handle/extension, i just used a normal ratchet for tightening it back up.

jdiaz135 · 02-26-2020, 09:05 AM

Thanks again

My last question. I know I need 1.6 quarts. One bottle is 1 qt, but whats the most efficient way to measure .6 qt to finish if off?

Mudflap · 02-26-2020, 09:07 AM

Oil drain bolt should be tightened to 18 ft lb per Honda CG shop manual.

**JerryHawk250** · 02-26-2020, 09:10 AM

Quote:

Originally Posted by jdiaz135

Thanks again

My last question. I know I need 1.6 quarts. One bottle is 1 qt, but whats the most efficient way to measure .6 qt to finish if off?

It will only take a quart.

Megadan · 02-26-2020, 04:01 PM

Quote:

Originally Posted by JerryHawk250

It will only take a quart.

1.16 quarts to be exact lol.

imapdog · 02-26-2020, 04:05 PM

Quote:

Originally Posted by Megadan

1.16 quarts to be exact lol.

isn't it 1.16 if you pull the spark plug wire off the spark plug and tap the starter button a couple quick times to turn the motor over while draining the oil? if you don't do those things its 1 quart?

jdiaz135 · 03-04-2020, 09:16 AM

Hey guys, changed the oil. Where can i buy a new filter for the magician?

Also, i put more oil than i was suppose to. like 1.3 Is that bad? Or should i drain some out?

BuffaloChinaRider · 03-04-2020, 09:27 AM

Quote:

Originally Posted by jdiaz135

Hey guys, changed the oil. Where can i buy a new filter for the magician?

Also, i put more oil than i was suppose to. like 1.3 Is that bad? Or should i drain some out?

On my storm when I put even just a little bit more than it should take, it spit it out in an oil leak until it was at the right level, not sure if that will happen with your bike and you put .3 extra. Best test is just to run with it and see if it spits any oil out. If you want to be safe though just take some oil out with a suction or a turkey baster like tool! Good luck

**JerryHawk250** · 03-04-2020, 09:30 AM

Quote:

Originally Posted by jdiaz135

Hey guys, changed the oil. Where can i buy a new filter for the magician?

Also, i put more oil than i was suppose to. like 1.3 Is that bad? Or should i drain some out?

You shouldn't have to replace the screen filter. Just clean it. If you have to replace it look on ebay. https://www.ebay.com/itm/1970-1975-H...gAAOSwYSFdyK1e

jdiaz135 · 03-04-2020, 09:32 AM

Ok! It only has 400 miles on it. I wasnt planning on changing it, but thats a relief that i dont have to replace it.

jdiaz135 · 03-05-2020, 10:34 AM

Where is the oil screen filter located on the magician? Like I said I changed the oil, but because I can't figure out where the filter is, Ive been procrastinating.

**JerryHawk250** · 03-05-2020, 10:44 AM

It's the large hex shaped plug on the lower left side of the engine.

02-26-2020, 08:51 AM	#1
jdiaz135 Join Date: Nov 2019 Posts: 18	Oil plug on Magician 250cc Hey guys, So I have 400 miles on my magician. I bought oil and I am ready to change the oil for the first time but I cannot seem to loosen the oil bolt. Im using a ratchet but it will not budge. Its very possible that im just not using enough strength and that all I need to do is push a little hard and it may loosen but im afraid to hurt myself. Anyway, is there something that im missing or is it just simply VERY tight? Thanks!!
	0

02-26-2020, 08:55 AM	#2
JerryHawk250 Moderator Join Date: Oct 2016 Location: Houma, La. Posts: 11,562	Both my drain bolt on the bottom and the plug on the side where the filter screen is located were very tight on my Hawk and my X22R. Just makes sure you are turning lefty loosie. __________________ 2023 Lifan Lycan 250 Chopper 2023 Venom Evader 2022 Lifan KPX250 2020 Kawasaki Vulcan S 2004 Honda ST 1300 2016 Black Hawk 250 (sold) Keihin PE30 carb,125 main,38 slow.Pod filter,ported & decked head 10:1 CR,Direct Ignition Coil,15/40Sprockets,NGK DPR8EIX-9,De-Cat,Dual Oil Cooler,Digital Cluster 2016 Cazador180 XL 2014 Coolster150 JerryHawk250.com My YouTube Channel
	3

03-05-2020, 10:44 AM	#15
JerryHawk250 Moderator Join Date: Oct 2016 Location: Houma, La. Posts: 11,562	It's the large hex shaped plug on the lower left side of the engine. __________________ 2023 Lifan Lycan 250 Chopper 2023 Venom Evader 2022 Lifan KPX250 2020 Kawasaki Vulcan S 2004 Honda ST 1300 2016 Black Hawk 250 (sold) Keihin PE30 carb,125 main,38 slow.Pod filter,ported & decked head 10:1 CR,Direct Ignition Coil,15/40Sprockets,NGK DPR8EIX-9,De-Cat,Dual Oil Cooler,Digital Cluster 2016 Cazador180 XL 2014 Coolster150 JerryHawk250.com My YouTube Channel
	1

02-26-2020, 08:57 AM	#3
jdiaz135 Join Date: Nov 2019 Posts: 18	Okay, I figured. Ill try again. thank you
	0

02-26-2020, 09:00 AM	#4
imapdog Join Date: Feb 2018 Location: nashville Posts: 574	yes my two magicians were very tight on the drain plug. using a long handle/extension lefty way does the job. i did not attempt to re tighten it back with the long handle/extension, i just used a normal ratchet for tightening it back up.
	3

02-26-2020, 09:05 AM	#5
jdiaz135 Join Date: Nov 2019 Posts: 18	Thanks again My last question. I know I need 1.6 quarts. One bottle is 1 qt, but whats the most efficient way to measure .6 qt to finish if off?
	0

02-26-2020, 09:07 AM	#6
Mudflap Join Date: Sep 2014 Posts: 1,873	Oil drain bolt should be tightened to 18 ft lb per Honda CG shop manual.
	1

03-04-2020, 09:16 AM	#10
jdiaz135 Join Date: Nov 2019 Posts: 18	Hey guys, changed the oil. Where can i buy a new filter for the magician? Also, i put more oil than i was suppose to. like 1.3 Is that bad? Or should i drain some out?
	0

03-04-2020, 09:32 AM	#13
jdiaz135 Join Date: Nov 2019 Posts: 18	Ok! It only has 400 miles on it. I wasnt planning on changing it, but thats a relief that i dont have to replace it.
	1

03-05-2020, 10:34 AM	#14
jdiaz135 Join Date: Nov 2019 Posts: 18	Where is the oil screen filter located on the magician? Like I said I changed the oil, but because I can't figure out where the filter is, Ive been procrastinating.
	0