Hi Thumper! Wondering if you know how to tighten the steering stem on a XPRO 150 DLX? I just got one and the steering is very loose. There is a spanner nut above the center clamp with a silver colored cap under the clamp and handlebars. My question is, is there another nut under the silver cap and that the top spanner nut is a lock nut? Guess I just need to take it apart and see... Thanks for any help or advice...
Also, I took my carb off to find out why it was running at a super high rpm, when I went to do my weekly start up and run. Hopefully, i did not grind too much off of the stock bolts. I did manage to remove them completely. I'm heading to the store to get replacement bolts. If nothing else, I guess I'll order another carb. My Nibbi will not match up, at all.
I was able to post the pics in a different part of the Forum, but I can't do it her, for some reason. It asks me to: "Please enter the URL of your image:", but I'm not tech savvy. Guess I'm too old.
I am trying to buy stock factory decals for my 22 Templar and so far I have tryed a couple places and no one will get back to me where is a good place to get my parts sum place that will answer my call
Hi new here names Denver.i many on the ring form .by the way thanks for esepting me I really apritiate it .I've got a project I've been working on. It would take awhile to lay it all out but basically I got a motor I ordered a new cdi,rectifier,coils,for lifan250 8 pin cdi .I've got all pins hooked up except the bottom 2 pins on left side the tach and kickstand.im getting no fire do I need to ground the pin for kick stand to get fire is it a safety or something eny help would be apritiated greatly
My wiring is inside the protective flexible cover and zip stripped up on the fender. It is not visible to take a photo. All I did was remove the rear blinkers and reinstall the sequential in exactly the same connectors (remove and replace). I did not need to do any testing. I just kept track when I took off the original blinkers.
What about the brake light / running light? I have hooked up the metal proximity switch for the rear brake, ran the wire into the harness and have the tail light and rear turn signals working properly with the rest of the system however, no brake light engagement when either foot pedal or hand brake are depressed. The 3 wires on the rear tail light (brown, solid green, yellow/green stripe) could you send picture of how you have your tail light /brake wired together ? I would very very much need and appreciate that!!! That's the last missing link to the puzzle lol. Thank you for all your help ! í ½í¹
I don't know why the left rear is weaker. Is the voltage lower on that lead than the bright right side? LED intensity does depend on voltage.
No one has posted amperage on these bikes, so I don't know how much load it can take. I think it depends on the output of the stator, and the regulator/rectifier. Maybe drawing too much current (a super high amperage headlamp) could burn up the stator, but I admit I just don't know. It may also prevent other things to work if the headlight is on.
