Go Back   ChinaRiders Forums > Search Forums
Reload this Page Search Results
Register FAQ Community Calendar Today's Posts Search
Showing results 1 to 20 of 20
Search took 0.00 seconds. Search: Posts Made By: knwilson
Forum: Dual Sport/Enduro 01-27-2023, 07:00 PM
Replies: 19
Views: 9,290
Posted By knwilson
I thought they were "keyed" to only allow correct...

I thought they were "keyed" to only allow correct install? I thought I could only install it one way? I can unscrew that and take another look pretty easily though (I think there's room)...:hmm:
Forum: Dual Sport/Enduro 01-27-2023, 06:54 PM
Replies: 19
Views: 9,290
Posted By knwilson
Doesn't seem to be sticking. I can still rev it...

Doesn't seem to be sticking. I can still rev it and it releases instantly. Throttle response is actually really nice - way better than before with all the hesitation and wandering idle. Just way too...
Forum: Dual Sport/Enduro 01-27-2023, 06:20 PM
Replies: 19
Views: 9,290
Posted By knwilson
Angry Running, but idle is 6-7K RPM

I had a few minutes this afternoon so I pulled the carb out again, double checked the 120/40 jets and general condition/operation of the carb (mostly the choke setup). Everything looked normal to me...
Forum: Dual Sport/Enduro 01-22-2023, 11:26 PM
Replies: 19
Views: 9,290
Posted By knwilson
Now that the old one is out, I may try to get it...

Now that the old one is out, I may try to get it apart to rejet. On the road for the next couple of weeks though, so this is going to sit in the shop, as is, until I get back...

Not the petcock,...
Forum: Dual Sport/Enduro 01-22-2023, 07:53 PM
Replies: 19
Views: 9,290
Posted By knwilson
Well, it took me about 2 hours, but I finally got...

Well, it took me about 2 hours, but I finally got it install. Unfortunately, it’s didn’t help and actually can’t even get it started now. Got it started briefly by putting some starter fluid down the...
Forum: Dual Sport/Enduro 01-21-2023, 01:11 PM
Replies: 19
Views: 9,290
Posted By knwilson
Thanks for the input. I think I am going to...

Thanks for the input. I think I am going to remove the exhaust pipe and maybe the gas tank to see if that makes enough room to tighten the nut. I’m sure I’ll figure it out with enough patience.
...
Forum: Dual Sport/Enduro 01-21-2023, 09:53 AM
Replies: 19
Views: 9,290
Posted By knwilson
Templar X 250 Nibbi PE 30mm Install

It’s me yet again… It took me about an hour of twisting and turning, but I finally was able to remove the old/stock carb. However, I cannot figure out how to get the new Nibbi carb installed. I...
Forum: Dual Sport/Enduro 01-20-2023, 02:45 PM
Replies: 15
Views: 6,385
Posted By knwilson
What's your elevation if you don't mind? I am...

What's your elevation if you don't mind? I am installing a Nibbi 30mm this weekend.

It comes with the following:
1 x Slow Jet
Available Size #40
3 x Power Jet
Available Size: #120 122 125
...
Forum: Dual Sport/Enduro 01-20-2023, 01:01 PM
Replies: 10
Views: 2,142
Posted By knwilson
No real reason other than lack of confidence in...

No real reason other than lack of confidence in my own mechanical skills. Hate to tear into the engine if I don't have to. I have adjusted valves before on an old Honda Trail 90 I have, but did so...
Forum: Dual Sport/Enduro 01-20-2023, 10:39 AM
Replies: 10
Views: 2,142
Posted By knwilson
I ordered a Tusk In-Line Fuel Filter: *Fits...

I ordered a Tusk In-Line Fuel Filter:
*Fits with standard ¼” fuel line between the fuel tank and carburetor
Clear housing design
1” sintered bronze filter
Dimensions: 7/8” x 2 ¼”

I also...
Forum: Dual Sport/Enduro 01-19-2023, 09:50 PM
Replies: 10
Views: 2,142
Posted By knwilson
Question Templar 250X Fuel Filter

Turns out I am still leaking gas. Best I can tell, it’s coming from the fuel filter. Anyone know what I need or have a link for a replacement? Going to try swapping to NIBBI 30mm this weekend and...
Forum: Dual Sport/Enduro 01-18-2023, 12:00 AM
Replies: 1,922
Views: 1,087,986
Posted By knwilson
Well I got it running again today, but it's...

Well I got it running again today, but it's pretty rough. I sprayed some started fluid into the spark plug hole and it fired right up. Some sort of fuel issue so I checked the petcock valve and...
Forum: Dual Sport/Enduro 01-16-2023, 07:00 PM
Replies: 15
Views: 6,385
Posted By knwilson
Wow. I don’t know why I never thought to use the...

Wow. I don’t know why I never thought to use the rear brake. Didn’t know that would work…

Thanks for the insights.

Now back to figuring out why the hell this thing with 4 miles on it won’t...
Forum: Dual Sport/Enduro 01-16-2023, 02:20 AM
Replies: 15
Views: 6,385
Posted By knwilson
Disable Front Brake Requirement to Start - Templar Pro X 250

Anyone know if it's possible to disable the "feature" requiring the front brake to be held/engaged in order to start the Templar Pro X 250s?

I am fighting some starting issues and it's getting...
Forum: Dual Sport/Enduro 01-04-2023, 10:24 PM
Replies: 1,922
Views: 1,087,986
Posted By knwilson
Couple problems - might be related?

Hey all - I have been fighting some problems with the new bike. Everything was working well after assembly, but then yesterday I noticed it had leaked a good amount of gas the weekend while it was...
Forum: Dual Sport/Enduro 12-23-2022, 02:34 PM
Replies: 1,922
Views: 1,087,986
Posted By knwilson
With the speedometer on the odometer screen,...

With the speedometer on the odometer screen, press the button to switch from KPH to MPH.

To select the wheel code/circumference, turn off the key, hold down button while turning the key back on. I...
Forum: Dual Sport/Enduro 12-23-2022, 01:41 PM
Replies: 1,922
Views: 1,087,986
Posted By knwilson
I could use a little guidance... Mine is set to...

I could use a little guidance... Mine is set to 2182, but my MPH is way off. Just used GPS and at 25MPH, the speedometer is only showing 9MPH.

Anyone have any ideas?
Forum: Dual Sport/Enduro 12-04-2022, 12:41 AM
Replies: 1,922
Views: 1,087,986
Posted By knwilson
I appreciate the detailed reply. Sounds like it...

I appreciate the detailed reply. Sounds like it might just be easier to bring it to the shop vs bringing the shop to it. Wish me luck - I'm going to get started on it this week...
Forum: Dual Sport/Enduro 12-02-2022, 01:49 PM
Replies: 1,922
Views: 1,087,986
Posted By knwilson
Any chance anyone has a list of the tools needed...

Any chance anyone has a list of the tools needed for assembly? I just got one delivered, but it is not at a location I have tool. I was going to grab a bag of what I needed from home, but don't want...
Forum: ATVs 03-06-2018, 12:12 PM
Replies: 2
Views: 1,723
Posted By knwilson
Help finding parts for Viper 110 Quad

Was just given a couple old quads and would like to get them cleaned up and running for my son. I cannot find any information on where to get parts.

Attached are some pics. The black on obviously...
Showing results 1 to 20 of 20

 
Forum Jump

All times are GMT -4. The time now is 01:40 PM.

Contact Us - ChinaRiders.net - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.