I checked all the fluids... clean and full... nice for a "beater".
I set the valve clearances, .002" intake, .003" exhaust... intake was a tad loose, exhaust was spot on.
Removed the EGR valve and components. Crimped and soldered the exhaust outlet pipe off the engine (in lieu of a nicer block-off plate).
I've tested the stock DC CDI... and could not get any spark... got a new one coming.
Ordered a new ATV wiring harness... hope it has all the correct plugs and wires needed... and that the colors maybe match one of the wiring diagrams I found.
It's got the same '07-ish (no tamper-proof screws) Keihin-clone PZ30 carb on it that my Runmaster does. Which is sweet, since I still have jets left over from dialing that one in. Carb is in nice shape. I did have to buy a new intake manifold elbow... the rubber was torn on the original. I've decided to ditch the crappy airbox setup and go with a pod filter. (I won't be fording any water crossings or anything). I'll jet the carb accordingly.
Being a no-title, no-paperwork project... can someone direct me to where I could find the VIN on this? I've looked all over the frame and can't seem to find any stamped numbers (besides on the engine).
Cheers!
|