03-13-2011, 08:27 PM
|
#1 |
|
Join Date: Feb 2010
Location: Hartwell, GA
Posts: 187
|
T12 and T13 Sprockets Installation on a Zong
On the web sight I purchased the sprockets from it said:
Note: 12t and 13t sprockets require a circlip to hold part on shaft Anyone that has used the 12T or 13T on the Zong, did you use the clip that came with the sprocket? I popped on the clip that came with the sprocket and its on good, very hard to pry off so I wanted to check to see what others used. Not sure if this could of been a Yamaha problem. Anyway I wanted some advice because I couldn't find my set of circ pliers and the factory clip seems to be secure. Thanks, Alan
__________________
Zongshen Sierra Mods: knock off DRC Edge II Taillight , FMF Turbine Core 2 Silencer, Halogen bulb, 18" Wheels, Real Tires |
|
|
03-14-2011, 02:14 AM
|
#2 | |
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
Re: T12 and T13 Sprockets Installation on a Zong
Quote:
 If the PBI circlip is attached properly, it is very secure.  Spud
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
|
|
|
03-14-2011, 09:12 PM
|
#4 | |
|
Join Date: Jul 2008
Location: Idaho
Posts: 25,054
|
Quote:
Spud
__________________
Spud "Never argue with an idiot. He will drag you down to his level, and beat you with experience." Mark Twain2015 Zongshen ZS250GY-3 (RX3) 2006 Zongshen ZS200GY-2 (Sierra 200) 2005 Honda XR650L 2004 Honda CRF250X 1998 Kawasaki KDX220 Mods made to my Zongshen ZS200GY-2: http://www.chinariders.net/showthread.php?t=6894 |
|
|
|
|
|
|
 |
|
|
Linear Mode
