08-16-2007, 08:56 PM | #1 |
Join Date: Feb 2007
Location: CT/VT
Posts: 5
|
New bike not running right
Just got a new Lifan 200gy and put it together. Only problem is that I can't get it to idle right and it seems to be misfiring. It's making a popping noise from the exhaust.
Any advise on what to check or adjust? |
|
08-16-2007, 09:45 PM | #2 |
Join Date: Apr 2007
Location: Toronto Ontario Canada
Posts: 2,585
|
I'm too new to advise anyone on anything, and I'm sure someone will come along and give you good advise, but since no one has replied yet, I'll step up and look stupid. :?
If it were me, when my bike was new, I'd suspect the gas purity. The tank sometimes gets dirt in it from shipping. I'd think about dumping the gas and using a flashlight to inspect the tank. Since the bike has been started, that dirt might be in the carb, it too might need cleaning. But then again my best advice to you, is not to listen to me. I just feel bad for ya bro. Check stuff and do no harm till someone brilliant comes along and types out what the problem is. |
|
08-16-2007, 10:39 PM | #3 |
Join Date: May 2007
Location: Altamont, Kansas
Posts: 15,103
|
I may be set too lean. What is you elevation? You probably will need to lower the carb needle and adjust the mixture screw.
Does it improve with the choke on? Good sign that it is too lean. Also check the sparkplug for a proper gap and you may want to replace it with an NGK plug. Allen
__________________
You meet the nicest people on a Honda Clone. |
|
08-16-2007, 10:42 PM | #4 |
Join Date: Jan 2007
Location: Bradenton, Florida
Posts: 1,200
|
Cheyenne,
Alot of the GY's have some leftover plastic shavings in the tank from production, you may want to drain your tank and see if anything is floating in there?? Carb next?? Welcome to the site and ask away...
__________________
06 Lifan 200 GY-5 |
|
08-16-2007, 10:45 PM | #5 |
Join Date: May 2007
Location: Altamont, Kansas
Posts: 15,103
|
I blew the tank out with the air compressor first and then installed a fuel filter during prep.
I haven't seen any shavings or dirt in the filter yet. Allen
__________________
You meet the nicest people on a Honda Clone. |
|
08-16-2007, 10:57 PM | #6 |
Join Date: Mar 2007
Posts: 732
|
It's on the lean side. I did the C clip mod and mine idles great and no backfiring.
|
|
08-17-2007, 01:22 AM | #7 |
Follow the DS prep guide in the Tech section of the website nip most of these little problems in the bud. We've all had them and they're documented there.
__________________
2009 XR650L Big Red Pig Tusk bar risers 2007 X-Moto(Jetmoto) GY250 --mods--- 15/40 sprockets UNI Pod Filter 2007 Shineray TMS 200XYi--Betsy Betsy Mods:______________________ Acerbis DHH headlight FMF Powercore pipe Uni Pod Filter |
|
|
08-17-2007, 01:22 AM | #8 |
Don't forget the LocTite!
__________________
2009 XR650L Big Red Pig Tusk bar risers 2007 X-Moto(Jetmoto) GY250 --mods--- 15/40 sprockets UNI Pod Filter 2007 Shineray TMS 200XYi--Betsy Betsy Mods:______________________ Acerbis DHH headlight FMF Powercore pipe Uni Pod Filter |
|
|
08-17-2007, 09:08 AM | #9 |
Join Date: Apr 2007
Location: Toronto Ontario Canada
Posts: 2,585
|
8O I wasn't too far off for a new 2 rider.
Kato's suggestion, " Does it improve with the choke on? Good sign that it is too lean." is a great quick test. If it gets worse, then you are too rich. If it gets better you are too lean. Hope you are up and running soon, good luck |
|
|
|
|
|