ChinaRiders Forums - View Single Post - Adding brake lights with 4-wire turn signals

detours · 05-31-2016, 01:29 AM

Now repeat Steps 6 and 7 with the right rear turn signal.
When you are done, both turn signals will function normally, as seen in this 'after' pic of my hazard lights flashing.
Follow the steps in reverse order to bolt the tail assembly and body panels back on.

In Part 2, where I splice in the running lights, brake and tail lights, you will only have to remove the electrical panel. The hard part is done

05-31-2016, 01:29 AM	#9
detours Join Date: Sep 2014 Location: Arvada, CO Posts: 1,004	Step 8: Replace the remaining turn signal Now repeat Steps 6 and 7 with the right rear turn signal. When you are done, both turn signals will function normally, as seen in this 'after' pic of my hazard lights flashing. Follow the steps in reverse order to bolt the tail assembly and body panels back on. In Part 2, where I splice in the running lights, brake and tail lights, you will only have to remove the electrical panel. The hard part is done Attached Images __________________ Red 5 standing by! 2015 CSC red RX3 with 19" front wheel, Shinko 804/805, skid plate, tall seat, 13T/45T sprockets, progressive shock, Winyoochanok windshield, GENSSI LED headlight, SW-Motech tankbag, Shorai Lithium battery 2014 Ural Patrol
	1