Homemade PVC fork spacers ???

[Bill Hilly]

I made some 1.5" long, and I think it was too much, It didn't sag hardly any under my weight unless I plopped down kinda hard on it, and then it wasn't much. I pulled them back out, and trimmed them down to 1 . 1/8" and I think it's about right. I was surprised to see that the stock steel spacers were about 5" or 6" long. They probably skimped and used shorter than optimal springs.

[Megadan]

Originally Posted by Bill Hilly

I was surprised to see that the stock steel spacers were about 5" or 6" long. They probably skimped and used shorter than optimal springs.

This has me curious. They may have changed the springs they used in the forks if your spacers are that long. Both of my Hawks had enormous springs with little tiny 15mm spacers.

As far as material. Yes PVC will hold up just fine if it is what you have. Otherwise almost any sort of metal tubing will work as well. I used bronze because it's what I had. Hard to beat free lol

[Ol,fart]

Originally Posted by Megadan

This has me curious. They may have changed the springs they used in the forks if your spacers are that long. Both of my Hawks had enormous springs with little tiny 15mm spacers.

As far as material. Yes PVC will hold up just fine if it is what you have. Otherwise almost any sort of metal tubing will work as well. I used bronze because it's what I had. Hard to beat free lol

They are about 1.5 on my 2021 I put a 17mm socket on top of them.