Homemade PVC fork spacers ???

Bill Hilly · 08-27-2022, 07:15 PM

I made some 1.5" long, and I think it was too much, It didn't sag hardly any under my weight unless I plopped down kinda hard on it, and then it wasn't much. I pulled them back out, and trimmed them down to 1 . 1/8" and I think it's about right. I was surprised to see that the stock steel spacers were about 5" or 6" long. They probably skimped and used shorter than optimal springs.

08-27-2022, 07:15 PM	#3
Bill Hilly Join Date: Feb 2021 Posts: 1,014	I made some 1.5" long, and I think it was too much, It didn't sag hardly any under my weight unless I plopped down kinda hard on it, and then it wasn't much. I pulled them back out, and trimmed them down to 1 . 1/8" and I think it's about right. I was surprised to see that the stock steel spacers were about 5" or 6" long. They probably skimped and used shorter than optimal springs.
	0