Operation: Red Hawk - Skyd's Build thread

Skyd · 05-09-2021, 01:51 PM

Ok just did the first start on the bike....started right up for the most part. It didn't wanna be full choked, half choke was best and then after not long no choke. Turned the idel screw up a bit and let it run for 5 minutes. It's cooling off now and I'll do another heat cycle. I'm not anal about break ins honestly but we'll do a few cycles and some low speed variable throttle for a bit.

One thing I need to address so far is that if I get on the throttle quick, it dies. Guessing I might have gone too big with the Pilot.

05-09-2021, 01:51 PM	#31
Skyd Join Date: Mar 2021 Location: New Hampshire Posts: 242	Ok just did the first start on the bike....started right up for the most part. It didn't wanna be full choked, half choke was best and then after not long no choke. Turned the idel screw up a bit and let it run for 5 minutes. It's cooling off now and I'll do another heat cycle. I'm not anal about break ins honestly but we'll do a few cycles and some low speed variable throttle for a bit. One thing I need to address so far is that if I get on the throttle quick, it dies. Guessing I might have gone too big with the Pilot. __________________ 2020 RPS Hawk 250 - Build thread can be found here: http://www.chinariders.net/showthread.php?t=28374 "Do Wheelies and Forget your Feelies" "If vegetarians eat vegetables, what do humanitarians eat?" -unknown Last edited by Skyd; 05-09-2021 at 03:09 PM.
	0